|
 |
Speed Dome Camera General Failure Analysis
| Q1 : |
After power on, no motion and no image. |
| Q2 : |
Self-test is exceptional, there is image but with
motor noise “moo”. |
| Q3 : |
Self-test is normal, but there is no image. |
| Q4 : |
Self-test is successful, but can’t control. |
| Q5 : |
Image is not stable. |
| Q6 : |
Dome device is not controllable. |
| Q7 : |
Iris of the Dome device is not controllable. |
|
|
Q1 : After power on, no motion and no image.
|
Possible Reason |
Troubleshooting |
|
Power supply module is
damaged or power is not enough. |
Change |
|
Power cable is
connected improperly. |
Correct |
|
Failure occurs on
engineering line. |
Eliminate |
|
|
Q2 : Self-test is exceptional, there is image
but with motor noise “moo”.
|
Possible Reason |
Troubleshooting |
|
Mechanism failure. |
Examine and repair |
|
Video camera is
slantwise. |
Put right |
|
Power is not enough. |
Change
power that meets requirements. It is recommended to place the
power switch near the Dome device. |
|
|
Q3 : Self-test is normal, but there is no image.
|
Possible Reason |
Troubleshooting |
|
Video line is
connected mistakenly. |
Correct |
|
Video line is poor
contact. |
Eliminate |
|
Video camera is
damaged. |
Change |
|
|
Q4 : Self-test is successful, but can’t control.
|
Possible Reason |
Troubleshooting |
|
Control signal line is
connected mistakenly. |
Correct |
|
Position of Dome
device does not match. |
Re-select |
|
Protocols are not
matched. |
Adjust the protocols
being match with the controller. Re-power on. |
|
|
Q5 : Image is not stable.
|
Possible Reason |
Troubleshooting |
|
Video line is poor
contact. |
Eliminate |
|
Power is not enough. |
Change |
|
|
Q6 : Dome device is not controllable.
|
Possible Reason |
Troubleshooting |
|
Self-test is
exceptional. |
Re-power on |
|
Control signal line is
poor contact. |
Eliminate |
|
Operation of Host has
problem. |
Re-power the host on |
|
Too much load or
communication distance is too long. |
1.
Confirm terminal
resistance
2.
Add code distributor
|
|
|
Q7 : Iris of the Dome device is not
controllable.
|
Possible Reason |
Troubleshooting |
| Iris
is in manual status. |
Use
control command to set iris to manual status and iris can be
controlled. |
|
| |
|
|
 |
|
©2010 Shany Electronic
Co., Ltd. All Rights Reserved
|
